Setup Your Bat Speed Recon Unit
01

APPLY REFLECTIVE TAPE
Place the reflective tape sticker over the end of the bat. This allows the bat speed recon to read the speed of the end of the bat.
If the end of the bat is cupped, try to keep the sticker flat across the top.
02

RECON & TEE SETUP
Place the tee approximately 18″-20″ away from the tee.
Set the recon back 1″-2″ back from baseball.
We want to record the bat speed directly before the bat impacts the baseball.
03

THE TIP OF THE BAT MUST PASS THROUGH BOTH LED ARRAYS
In order to collect a reading and determine the bat speed, the tip of the bat must pass through both led arrays.
04

LED ARRAY VISUALIZATION
The recon should be placed slightly below the baseball placed on the tee.
The array will disperse at a slight upward angle.